Thanks meta never done that before I guess I will have to get on my computer to down load from my phone from the instructions I read , but I don’t get it if it’s already on my phone?
Hey guys bought p3A factory refurbished drone from dicksmiths . Took for first flight and left it on beginner mode , but when flying it , it would occasionally say aircraft out of range . Should I ignore this?
You can’t get a device manual , just read about what others have done and watch a lot of u tube videos of repairs. No I don’t have a solution yet , but I put a donor gimbal board in and it points to the right . I tried pulling apart and putting old board back in and it points straight, so at...
Well I guessed this issue was too unusual for anyone to answer, but what did was put my old gimbal board back in and the camera sits straight. So I guess the donor board has issues.
Well don’t loosen grub screw and fire it up , it just spins.
I pulled gimbal board out and put old one back in and the camera sits straight , so donor board must have issues.
Yeh have even tried set the screw off the slot to compensate and still it goes to the right. Might try having totally loose and firing it up see what it does
Yeah tried both , no luck
I might pull it apart again put old board back in and if the camera points the right way then my donor board is ****. Thanks for your help
Hey guys did a firmware update and it only took 5 mins and the drone didn’t make beeping noises as it updated .
On the app it said it was completed but now camera faces to the right.
Does anyone know how to updated it again?
Hey guys crashed my drone back in may , I have had to replace a lot of parts and learnt so much about my drone thanks to all the posts on this forum. Just when I thought I would be back in the sky I have another problem. I bought a donor gimbal board and after the rebuild I had no video feed...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.