Recent content by Just4funXwing

Issue Solved! I opened up the camera and saw that one of the ribbon cables was not fully seated. Reseated the cable and focus is working again!

A sad chain of events... Crashed, repaired, working at 90%.... The Focus is not changing regardless of wether I use the manual settings or the auto settings. I turned on focus peaking so I could see the focus change, but no luck. I have refreshed the firmware, deleted and reinstalled the Go...

Ended up being a bad “new yaw motor”... Ted got it straightened out for me.

Thank you for your reply! I have fixed my fair share of phantoms and other drones, but not having a pile of known good parts makes it a real guessing game. I am a Vet and worked 15 years as a machinist, so my back ground is to not easily give up on any thing. So before wisdom gets the better of...

It finally happened, clipped a branch.... The gimbal broke off below the yaw motor... Where I am at is after replacing the the yaw motor, arm and ribbon cable, the camera works but the yaw roll are dead. At power up the pitch motor gos full up and full down then stays there. The Go app is not...

I put in a new yaw motor post crash and both yaw and roll are dead. Tried two new ribbon cables, still dead. Camera is working... Did you get yours fixed?

I have done the same yaw motor replacement, after a crash, swapped the housings, 2 new ribbon cables tried, but yaw and roll are still dead. Pitch works at power up, gos up and down then stays down. The yaw/roll esc is warm to the touch so I know it has power. What is the next step, which...