Recent content by joshtheman1

last question for the night. I have another main board from the "parts phantom." however, the compass input area broke off. if i tried to run off of the board without the compass plugged in, will I encounter the same issue or can it run without the compass input?

if i uploaded a short youtube video might that help at all?

tried it. didn't do anything different.

when you say swap the receivers you mean that thing with the endless grey wires?

thats fine any help works. so what would you recommend now then? I unplug the escs, but all i get is a beeping noise. nothing else occurs.

when i unplug the esc i just get an incessant beeping noise for that esc. same with all of them... thanks for your help by the way.

i went ahead and searched it a little while ago. but i don't understand what i can do to fix it if thats the issue.

What is the PWM? Im sorry but still learning all of the parts.

Hey david. So with what you're saying, can one ESC cause the whole phantom to have pairing issues or for the whole thing to not work? thanks!

tried everything the same. controller just wont bind. the only difference is this: when he gets to the point of turning on the rc controller, his lights turn solid yellow and his "bind" little light goes out like he said. mine never does that. It just keeps flashing and the yellow lights...

didn't work :(

will do. I just created a new thread and will post a video link.

Hey all! I need some help with my dji. I recently was gifted two dji phantom 2's. one working, one not working to use for parts. I put the battery in and the unit paired and I did the whole joystick thing to pair it and then the rotors started spinning in idle mode. However, we notices one...

I keep doing this and it just goes to two solid red lights, then back to flashing yellows fast. I can't seem to get it to pair. I do all of this turn off remote, turn off dji. flip over dji. turn on dji. press pair button once. turn on remote. press pair again. bring joysticks bottom and...

Todd, Have you figured anything out? My dji continues to flash yellow lights, the gimbal somehow connects to my controller, but I cant seem to pair it. I cant get the rotors to move or anything. updated all firmware ... kinda pissed.