Recent content by Jimmythegeek

13 is more than enough. Camera settings are way beyond me. I don’t even try. I don’t even know how to use all of the flying features. I just fix them.

Ahh, not sure if you were, but it sounds like you weren’t hooked up to enough satellites when you took off, or your controller may need to be calibrated. Once you get it nailed down you’ll love it. When I test the ones that I repair, one of the test I do is to fly it out of range until I lose...

Hi all, I’m in Brookfield Ct. been flying Phantoms for 6 years. I now refurbish and repair all phantom series drones as a side gig. I’ve sold well over 75 refurbished ones on EBay. If anyone needs help or has questions, just hit me up, I’d be glad to help.

Hi all! Before I start the long and arduous task of contacting dji support, was wondering if anyone is having an issue with trying to update firmware on assistant 2 for phantom? I deleted assistant 2 and reloaded it from the website on my Mac but no matter which drone I hook up to, and that’s...

No thank you

Lets see what you got

Best thing to do at that point is to ohm out all of the windings to make sure you have continuity.

GL300E

I did not. I personally don’t think they do much. But not 100% sure. The only thing I can say is to put it in and send it up for a test flight. I mean if the pro’s have it, and the obsidians don’t 🤷‍♂️. That’s the only difference I can see between the 2 models. Beyond the different metals in...

I just finished repairing one that someone tried to fix. All of the motors looked fine. Upon closer inspection the person who attempted the repair tightened the three motor screws in to tight on two of them which In turn broke some of the windings inside the motor. You should always ohm out the...

No I’m sorry, I probably didn’t phrase that right. I’m talking about the other 4 wires. I know the two push in wires go to the power board. But the v1 legs also have the other 4 wires that snap on to the connectors on top of the 3 in 1. The white, black, grey, and dark grey. The v2 3 in 1 only...

Since there is only two push connectors for the antennas on the v2 3 in 1 , which two wires do you eliminate from the v1 legs? Or does it matter?

Try the legs up calibration. If that doesn’t work your going to unfortunately start swapping yaw motor hubs until you get the right one. Definitely put the original ESC board back in because the roll motor as well as the yaw motor are paired to it. The pitch motor is paired to the board in the...