I followed the update/install process as demonstrated in the video. I didn't feel particularly comfortable to turn off the Phantom when the install process was at 84% (as noted in the process that not allowing the process to "complete" would risk rendering the drone inoperable). It appears...
I think I may have lucked out. After 20+ minutes of sitting at 84% I disconnected the cord from my iPad to the drone and reconnected it to the controller and re-synced to the drone and it said I have the current firmware.
The drone lights didn’t flash abnormally, so I shut everything down and...
Help,
I was attempting to upload the latest firmware V02.00.0700, and got to 84%, and then a message pops up something to the effect of the device does not support ... then it pops off, and here I sit at 84% while the batteries continue to drain on both my iPad and the drone.
Am I toast????
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.