Recent content by jeffscra

  1. J

    New purchaser of Phantom 4 Pro

    Curious what the 10 apps were?
  2. J

    Phantom Vision 2 at the bottom of the lake...everything must go...

    Here are two of three batteries. One is brand new...the other is a year old. The third battery is a new battery and is not responding so I am in the middle of exchanging it for a new battery. Once i get it back I will sell it as well. Thanks
  3. J

    Phantom Vision 2 at the bottom of the lake...everything must go...

    I'm in Plainfield, IL Suburb of Chicago and yes they do.
  4. J

    Phantom Vision 2 at the bottom of the lake...everything must go...

    Guys, the bird is sitting in about 25 feet of murky lake water. We tried for about 3 hours to retrieve it but no luck. So there she sits. So I guess I won't need any of these other items. My bird had maybe 20-25 flights tops. Wasn't used that much. So this is what I have. I can send...
  5. J

    Altitude is off....

    That plus the compass calibration seems to have worked! Thank you
  6. J

    Altitude is off....

    still says i'm at 42ft after calibration. Also I have one of the original flytrex's installed and that data is all over the place too. Stating I have flown on my last flight almost 450 ft up when I never went above 50 ft.
  7. J

    Altitude is off....

    Thank you....I will run that and then take it out and fly it and see what i get. Too windy here today though.
  8. J

    Camera wire extension...

    I've loaded my chinese gimbal and I have a 5 inch 3.5 mm extension cable on it however the cable is a little stiff. I know I saw on here that some bought a 3.5 mm cable that was coiled and bent a lot easier. Anyone have a link to this cable? Thanks, Jeff
  9. J

    Altitude is off....

    When I fire up my Phantom 2 vision on the ground it says its at 46 ft. Shouldn't it read 0 or 1 or 2 or something close to the ground? Thanks, Jeff
  10. J

    Can't Connect Phantom 2 Assistant via USB

    Thom....did you get this figured out? This is exactly what mine is doing now too.
  11. J

    Circuit board in and now....

    Thanks....anyone else change out their main board? Did everything come back or did they need to update the board once installed? I'm guessing it doesn't have the right firmware on it to begin with.
  12. J

    Circuit board in and now....

    Tried all three ports on my laptop and tried two cables. It worked fine before I replaced the board. Its like the PC is not recognizing the Phantom.
  13. J

    Circuit board in and now....

    Ok, folks, so I wasn't getting any telemetry data and no battery info. So I replaced the cable going from the camera to the main board. No help. Same issue. So I had read that others had replaced their main board and it helped them. So I bought a new main board and installed it. I can...
  14. J

    Chinese Gimbal Part 2...

    Ok, so I got the gimbal on the vision 2 and I have it relatively in a good spot I think. So I take it outside to test it and now I can't get any battery information or satellite information. I did very carefully solder the power directly to the main board feed. The vision powers up fine. The...
  15. J

    Chinese Gimbal Install Help

    Wow, thank you....so much information. The video was quite helpful as well as your links. I think I have a much better idea of what I'm doing now thanks to your response. Off to the store to get some parts. Thanks again!