Recent content by j437a

All wires are plugged in making sure of that because I have and additional P1 to go by.

Like i said the transmitter and receiver are talking a little but not enough to come out of fail safe mode. When I turn the transmitter on the light on the receiver turns green. Once I turn the transmitter off the light on the receiver turns red and I'm still getting a flashing yellow light...

I swapped out both terminals to see if that was change anything an it did not. Still getting flashing yellow light. R/ John

The receiver and transmitter lights are green but the phantom is flashing a yellow light continually which means its in the fail safe mode. How can I get out of fail safe mode? R/ John

I'm in failsafe mode and I don't know what else to do to get out of that mode

I ordered a new receiver board which is stamped 2.4ghz and when I turn the transmitter on the light turn from red to green.

At first I though is was the receiver because the light was not coming on so replacing it I got a light still having the flashing yellow light with both RX and TX bind. Changed out the board no joy still have the flashing yellow light. Changed out the flight controller still have the flashing...

I know that when this yellow light is flashing the transmitter is not talking to the drone i.e. receiver. On this drone the reset button is in the battery bay for re-binding the transmitter. Before I would see a red light on the reset button but now I don't see anything. Without any indication...

I'm back to the drawing board. I received the DJ6 and the binding red light goes out in the battery bay, but I have another problem. I have a continuous yellow flashing light. On the NAZA software it say I have a configuration error with my transmitter. Okay I used the RC assistance software for...

Thanks everyone I did a little bit of research on the receiver and it has two antenna's which is on the phantom 2 not 1 @ 2.4 ghtz output. The remote that work with the unit is a DJ6 and I was trying to bind a SR6.

Like I said in the previous post I have the phantom hooked up to my computer and once clicking the binding button it flash for 3 seconds and turn back red. Any help would be very appreciative. R/ John

The remote don't have a port to plug it into my computer for the NAZA software.

I'm trying to bind by phantom one with a new remote and it will not bind. The light is red in the battery compartment, but once I click the binding button it only flash for 3 second and turn back red. This is with the remote in the off position. R/ J

Also in the NAZA software it only show the main controller and the GPS on the FC40 and my Phantom 1 which works off of 2.4ghz. The NAZA V2 software is downward compatible with 1st gen phantoms.

main controller with the latest firmware 4.02 is listed along with the GPS