Recent content by hsp

Measure volt in 8 connection to gimbal at drone PCB 1-GND 2-GND 3-12v+ 4-12v+ 5-2.0v+ Wrong what function to that should probably be 3 or 5v? 6-3.1v+ wrong ------------------------- 7-2-37+ wrong -------------------------- 8-3.1v+ wrong ---------------------------- Could be...

Change ribbon and now Green light ended with reed then no light from signal diode for camera that came in loop still weak signal at APP in phone

At You tub video start mount at Camera this is not The best way. Look at ATK Phantom repair Web site US they start at Gimbal Board. Most tricky tod-o at You tub way is to mount at Gimbal board. Use the broken cable to be good to mount it safe and use a pin with soft top to press on cable in...

A lot of Sand is best and cheapest cooling and air tight, no cloth is tight against gas from LI-PO fire in cloud Nomex who in used in fire protection cloth That are reason to not use or store damage battery indoor.

your nbr is from Drone pcb (se nbr don't get any result At Google pict.) I write about gimbal pcb no result at scan tag from DJI Where did you get al parts nbr from DJI I Look to get service manual ,to repair drone and ev RC

apologias I don't understand anything

do you now Dbi at antenna in RC and Drone Why get better antenna from ground Langer range then modify both to same Dbi

Did you have org. Antenna At Drone?

Gimbal PCB look same but Drone ?

ok

More info from issue weak signal remote control. -1 Haw check Gimbal PCB measure different point GND to GND OK and 12,0 v,3,3v at both place and 5,0 Al OK. No visual damage at PCB temporary long distance red blink from diode .if you twist motor the beep be weaker. -2 No result to link Drone to...

Why flies in foggy weather temperature under zero if not serous businesses payee photo jobs. If you fly in low attitude and no wind you can still fly down to 3-5% if battery has same voltage on all cells and fresh and quick take charge. Warm up battery inside a jacket before if it under 10...

NO Usb to phone wi-fi to RC from Phone says ok Look good inside RC no difference if cabel to ofdm if you mean indoor protection control smal box behind Gimbal. Is connect or not. Have even take away ribbon to gimbal no dif. Still weak signal to RC no damage at Antenna inside Landing gear...

No. I should open it and take a look but it was drone that flight in a tree and damage gimbal for erlier owner RC looking new outside. I recognize from another P3 that camera has not the mowe then power button On eventually ribbon cable or mother board have same problems and that block to...

yes I think so because of message in field of signal and disconnected if you turn of RC.