Recent content by Homeless

  1. H

    Motor Overload Question

    Yeah got the spare set gonna give them a try just not a fan of dji chats default response of send in. You would think they more than anyone would know the reasons behind there error codes.
  2. H

    Motor Overload Question

    It's not that it's hard to screw the thread does not seem to catch properly. Never had a crash touch wood.
  3. H

    Motor Overload Question

    If a motor had to spin quicker it would draw more current. Then I suppose it could trigger the error if its monitoring that metric
  4. H

    Motor Overload Question

    So the error occurs when a particular motor spins quicker than the others am I understanding that bit right. Would a dodgy prop cause one to spin more suppose it could. Thanks
  5. H

    Motor Overload Question

    Thanks for the reply. I have not tried another propeller yet I shall tomorrow I didn't want to risk it If it was a fault. Speaking to chat they said it's a internal error that it needs to be sent in. I was only enquiring with them as to what causes it as you would think they would know. I...
  6. H

    Motor Overload Question

    Also do I need to send it in or is it the support chat staff not knowing what is going on
  7. H

    Motor Overload Question

    Yeah defiantly motor overload warning. Do we actually know what causes the warning is there any documentation of what causes or how it's measured. There's no sensors on the props so it must be calculated from something. Any idea what ?
  8. H

    Motor Overload Question

    Think the thread in the prop is shot others on the same motor are fine
  9. H

    Motor Overload Question

    It flys fine I was just wondering if this could trigger the motor overload warning
  10. H

    Motor Overload Question

    Yeah it is just that prop it does it on the other grey tipped motor as well and another prop on that motor fits fine
  11. H

    Motor Overload Question

    Iv had this a couple of times now and on inspecting my props before the last flight I noticed one of them will not screw on correctly. Where the others spin freely and then tighten one just spins with the motor at the Same time as if it does not thread. Do you think this is the cause of the...
  12. H

    Charger Question

    Voltage conversion. Mains to battery
  13. H

    Charger Question

    Right I'm guessing it's the box that handles the conversion from the wall
  14. H

    Charger Question

    Thanks you got one of the end that goes into the wall
  15. H

    Charger Question

    Figure of 8 is the cable that plugs into the block and goes in the wall