i have a phantom 3 advanced with gimble disconnected and no image transmission after firmware upgrade 1.11.20
the gimble will not read card with old firmware or connect to computer after pressing the relink button on ac when powering on
the light on the front of the gimble never comes on
can...
thanks cheddarman are you shure that you sent me to the right thread as this is not my problem
i was in your village at the beguinning of august on holiday
herbie
thanks again for your help
is there any way that i can get the ac into downgrade mode other than switching on with formatted sd card inserted with the bin file on it or in the app holding on the 3 bars see attached photo
forgot to say everthing worked ok before upgrade
i have downloaded 1.11.30 but ac will not go into upgrade mode with sd card in slot after powering up ac
thanks for your comprehensive reply
did relinking and restarting but still getting gimble disconected and no image transmission signal
rc when connected with usb cable to ac or usb stick did not update and tried different cables
not shure of previovs versions
app3.1.58
ac 1.11.20
rc 1.9.2
hi all
i did a firmware upgrade to 1.11.0020 and now i get a msg gimble disconnected and no picture from camera
the controller connects to ac and will fly
when i go into the up/downgrade menu the firmware is not listed so cannot proceed
connect a usb cable from gimble to computer nothing...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.