Recent content by Halda

Yes absolutely.

Bought a damaged ph4 pro v2 from Ebay. Description was flown twice then crashed into a tree landing. Drone lights up and connects to remote but no start up tones no errors in screen but doesn't report battery voltages or any drone info or gimbal. Also on connection wont let me name drone. Found...

This is from RC forum translated from Polish is go pro hacking software going to be a help or is this referring to a different part of the software. Well, it's a pity that the topic is not mentioned that this is about p3 pro / adv. For the 'standard' version the method is known. Generally, in...

So I need to work out how to program ambarella nand while it’s onboard if possible. So find the wiki on the a7 and hope the a9 is similar.

If I tap Ambarella on advanced board with putty it gives this output not sure it tells us much on the pro board there is no output at all.

If i tap Ambarella Uart under board using U0_T and U0_R on either of the boards should i get any output on putty ?

Ok so I have 2 gimbals original advanced and a pro that i have been working on through these threads. Is there any point in taking nand from advanced and fitting it to pro i understand it would be limited to 8fps for now. The advanced doesnt give any respose to putty although i think i now...

Just to add copied the image file to c:\users\”current user” seemed to stop file not found error now I have a new error nand open<>.

Bought a powered usb hub. Renamed the file copied it to root. Checked the properties. Still no joy. Does anyone have a solution to it. Can’t see why it’s not seeing file. Are we sending the exact same line both times should second time not be different ?

Is this a success or has it failed on ubl1.img I have triple checked the image name. The other part that I dont get is that unless I have board powered up before I start Putty it crashes Putty with a com error. So if i boot by connecting ground or 3.3v Putty crashes. Its Usb 2 port which...

Is bootloader the same as U-boot ? Then i need TI utilities to do the flashing and u-boot.img. This u-boot.img is that from the texas instruments site or from DJI upgrade files ? and the chip is a DM365 and software is appropriate to that.

Just to make sure am connecting everything correctly. FTDI Gimbal Top Board RX..............TX (368_U0_TXP) TX..............RX (368_U0_RXP) GND.............GND 3.3V............3.3V 5V..............5V Board connected externally not connected to drone at all. Run Putty set to serial...

Getting a second hand board from eBay on probably Wednesday. It’s off a phantom pro. Does this mean I should upgrade firmware using the Pro version. Will it give me any other complications.

Found how to get into logs on iphone have to use itunes. Have added logs not sure what they tell us.

The RC is a model C. I upgraded the firmware on the RC using an iphone X so does this mean the logs arn't available like they are on an android. Going to read up on connecting the FTDI to the gimbal top board not sure if i need 3.3v or 5v and am a bit lost after connecting will do further reading.