Recent content by gluton

I don't assume that all assistants offer to change this settings, that why I said "and any others Phantoms which you can modify this parameter". But if you say that Phantom 2 doesn't have this settings available, that mean owner bellow Phantom 2 should have this setting available and should...

I can affirm that this feature is available for my FC-40 by the NAZA-M assistant I downloaded from DJI. Maybe my NAZA has been changed by the previous owner, I can't tell and I don't know how to check. I just made new tests switching the settings from "Inteligent" to "Immediatly" and It's...

By navigating into the NAZA-M assistant, I found this : Yes a DJI PHANTOM FC-40 and any others Phantoms which you can modify this parameter can have the motors cuted-off during a flight by putting the left stick (Throttle) full down. It's just depend of the settings of this parameter...

Thanks for the anwsers. I've readed that the altitude is measured by a barometric sensor and, if available, by GPS. And I've also readed IMU calibration is to calibrations differents things like the barometric sensor. I haven't done an IMU calibration and it was the first fly of this Phantom...

This is at least a Phantom 2 and the engines doesn't stop : and this is from P3P manual : So I'm not sure to understand

I barelly readed everywhere that it's something that shouldn't happen during flight. And if it's the case, I don't understand this choice because It seem to me very dangerous when you want to loose altitude o_O.

Hi everyone. I just got a FC-40 and I crashed it today, on first fly ... I put the left stick to full down position to make him go down. The drone was going down then after few seconds, the motors cutted off. I wasn't touching the right stick. I've read that this behavior isn't normal. (I hope...