The replacement for the 'bugged' P3A is arrived. On this one the light of the Camera Status Indicator is on (green light). Probably in the old one there was a problem of connection between mainboard and camera ....
As Oso suggest I'll wait before update any FW. Does anyone know where find the...
Thanks again Oso,
the idea of a problem on the connection cable was great but I try to unplug and re-seat the 2 cables but any positive feeback from the drone. Any light from the Camera Status Indicator and, after about 10 seconds after the 'show' at boot of the gimball the camera point the...
The DJI GO start on Phantom 3 professional and I can't change
Actually DJI GO in Overall Status tell Updates Required and I follow the instrucitions ...
I haven't check
Because if I try to start engine with CSC I receive a message 'Aircraft firmware Inconsistent ....
Yes and yes
No the...
The camera options are not available. I try to change the SD but the result is the same. This is the picture: is a P3A! I don't want to try with a different FW. Probably it will fly back to the seller ... :-(
Hi to all, I open today the box of my new P3A. Recharge all batteryes and turn on everithing. First strange signal: the DJI GO is connected to a P3 Professional ... strange. Then, show me to update firmware of controller and drone, ok I start from controller and it go. then I calibrate the...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.