Recent content by froggy8

  1. F

    manual mode

    when i used the cheerson, it was so easy on stability mode. the only flying rc i couldnt fly was helicopters, they are so hard.
  2. F

    are these compatible with the phantom 2?

    which one is the chinese knockoffs?
  3. F

    manual mode

    hi i was wondering if anyone have tried manual mode? i used to have the cheerson cx-20 and i have flew that on stability mode, if i remember rightly, that is manual mode.
  4. F

    Lost in Heaven

    that looked very peaceful!
  5. F

    first outing

    did a video of my first outing earlier, for some reason it stops after 3 mins. hope you enjoy!
  6. F

    are these compatible with the phantom 2?

    i have just dug these out, i used to have a cheerson cx-20 which i believe is a copy of phantom and just wondering if i can make any use out of them? thanks i believe this one is a mini iosd, i could be wrong though.
  7. F

    does this look fine?

    ok thank you, will have to try not too over tighten them. cant afford a new shell.
  8. F

    does this look fine?

    i have put a circle around the part i need, i think i might have tighten it too tight, it is tight but it should stop turning when i apply pressure
  9. F

    does this look fine?

    can you get the bit inside the shell where you put the screw in on its own?
  10. F

    does this look fine?

    thank you very much for all your help. you have been very patient.
  11. F

    does this look fine?

    i have now removed the black cover
  12. F

    does this look fine?

    i have done that and it goes straight to red flashes
  13. F

    does this look fine?

    thank you, i will remove the black covering now.
  14. F

    does this look fine?

    thank you Jason yes that was my first ever flight outside, was testing so didnt take it far. i have alot of trees around me so that was probably why the gps signal was poor. i thought you said i could put the cable to the side so it wont touch any components?
  15. F

    does this look fine?

    i think i understand what Jason meant, i tighten one screw on one side so it wasnt levelled, i have now corrected it
See more