Recent content by EddieR0691

most likely bad wifi module.

no it's not

1) litchi also recommends a higher end tablet...you can check their page for what is know to work well. 2) as marknmd says, must be built in to the tablet...

Have you tried copying them back to the sdcard and reinserting it into the drone? I would suggest doing it one by one so as to not confuse the camera. Also use a clean and reformatted card...

What I've found on other boards, and by experience, is that if the recording stops because of a crash or battery failure the video file is not properly "closed". Without removing the sdcard, put in a good battery and reapply power to the bird (no need for remotes or phones/tablets). Wait a few...

Don't install the beta version! Simple...use the release version and you'll be fine. I think you have to opt-in to even get the beta software. 2.7.1 is apparently the latest/greatest version supporting P2V and P2V+.

maybe something here can help you? OpenWrt/wireless – Gateworks or here: Wireless configuration [OpenWrt Wiki] and here: OpenWrt Wireless FAQ [OpenWrt Wiki] It looks like it's not a command but a config file that you edit using vi or something similar...not sure what's contained onboard the...

:) They would only be 1/10" longer... doubtful it would make a difference. I suppose you could make your own by cutting off the tip of one and gluing it to the end of the other...a little plastic shrapnel never hurt no one (much) LOL

yep, overeager typing finger and a non-detail oriented eye...9450's

my understanding is that the video/telemetry is xmitted on 2.4Ghz and the control TO the bird is on the 5Ghz channel. You may have some interference and/or control issues, it would depend upon the exact frequencies and harmonics plus the power levels of each transmitter. So basically, I don't...

I've got some 9550's on my P2V+ too. The sound is a little different and as mcajr37 says the thrust is improved...as it should be with a 5" pitch vs. 4.3" pitch I also find that it's a bit quicker to respond to stick inputs - so be careful if you're used to a "lazy" response.

That's a good find! Was it a used quad? maybe crashed earlier. Could just be defective cold solder joints too, as you found.

I would check the pitch of your propellers, you may have mixed and matched 9443's and 9450's. Usually very small raised digits on the upper edge of the blade near the hub. You may need a magnifying glass (or readers if you're old like me) and good lighting. You also may have some very...

you can use the "find my phantom" function in the settings area to see the last reported location...it may help you get in the right area.

You can try the coffee modded app from http://ilovecoffee.cf/ I have it installed instead of the official DJI app. However, if you are willing to pay for an app, the litchi app on the Play store is fantastic...although it also may not work on your older tablet.