Recent content by dreamlx

So you regained control during flight and could continue flying normally ?

Hi, I have heard rumors that if you assign fail-safe to the TX mode switch, and activate it this way, you will not be able to regain control. Did actually any one try this and was he able to cancel fail-safe ? Thanks in advance

Just out of curiosity: did you do an IMU and compass re-calibration after the firmware update or did it fly correctly without ?

As far as I know, a permit from ministry of defense is required in the Netherlands for all sort of aerial imagery except if you are taking the imagery personally from inside a plane.

Do you use the Xoar 9x4 on the Phantom or an other size ? I see that 9x4 pushers seem again to be difficult to get. Where did you buy them ? Did they already have an 8mm hole or did you need to redrill ?

Hi, I have tried Zinger wooden 8x5 propellers and have been very pleased with them. However it seems to be difficult to buy them from Europe. Xoar wooden propellers seem to be much easier to buy from Europe. Has anyone any experience with Xoar propellers on the phantom ? If anyone has used...

Hi, I am planning to buy a cheap notebook specially for using with the Phantom. As not much hardware resources should be needed, I am thinking at a Lenovo IdeaPad S206 M899FGE with Windows 8 64bit. Has anyone used the Naza assistant successfully on Windows 8 64bit ? Thanks in advance

Hi, Yesterday I tried the Zinger 8x5 props. I used the nuts delivered with the Phantom and fixed them with the supplied prop wrench. I tied them down with as much force as possible. On a first test, all went well. On landing, I had a tip-over due to a not very even landing surface and 2 props...