Recent content by DJIDrDan

The camera was pointing left, in level position the left leg in the middle of the picture

I taped it last Friday, had to do some areal pictures of ground work done at our local cross country ski tracks. After reading the same problem I had thought to see what would happen if I take it to the air today few days later. Seems back to normal, there was a lot of wind so the picture was...

I have just taken it for a test flight after the sellotape was removed. The camera is now pointing forward. Seems to have reset itself after being taped

I have exactly the same problem, replaced the gimble board and now the camera points left to the leg. Tried to tape it facing forward and gave a message of gimble motor over ride or under stress. Removed the Tape then it was pointing forward again for a while.

Had the same problem, bought the gimbal electronic board on ebay, fixed it. The one I bought has three integrated circuit boxes less but it works. Only problem is the camera is pointing left, think the shaft is not 100% centered, will tinker later today to fix that

I ordered a new gimbal electronic board from eBay, it is missing three of the little integrated circuits if compared to the old one. Will it work if installed on my P3P that isn’t transmitting the pictures

My new Vision plus has the same problem, DJI is going to replace it via Droneworld Cape Town even though I bought it from US Hobbies, Thanks to Anthony who contacted DJI in China.