Recent content by dirtbiker407

Okay the problem was connection. I resoldered the contacts on the boards with heavy bead and it fixed the problem. Just the compass error now. But the bird still goes in the air

Okay so I replaced all 4 motors. Still have esc error. Kinda does the D-D-D-D sound but half asses. motor 3 and 4 constantly beep not sure the problem

Well Well crap LOL. Yes I heard the boards can't take much. I really hope I didn't ruin the esc board. The cw motors will be here Sunday and the ccw motors will be here between the 3 and 5 of Jan. HOPE this solves the issue. It has to be the motors because when I reattached the wires I wound...

I think I may have ruined board them because on the wired that the wire strip are glued to were a ***** to get heated up enough. Took literally 20 minutes of heating to get wires to seperate from board

I refuse to take to professional at this point. They will charge out the ***. Plus I hear a lot of bad things sending it in to dji. People say they flew it once and esc error came back. Or it just fell out of sky. I did a trade on this drone on something I got for free so I wouldn't really be...

yes I sanded the he'll out of them got good continuity. Used flux and put a nice heavy solder on them. Still esc error. I have 4 new motors on the way. Hope that fixes the problem. Hope it's not the boards.

Also when I put the motors back on I bolted them down without other half of shell by mistake and damaged the copper windings in the motor a little. Not terrible but it's noticeable. Thinking that may be an issue as well

I replaced my shell on the phantom 4 and now it says esc error on all 4 motors. When I replaced the shell I cut motor wires and numbered them to put back in correct location. I used sand paper to remove laquor from wire soldered back together and used heat shrink tube to put back together. Got...

No. They said I had to send it whole drone to be repaired. said that you can't buy that board and that they have to fix it.

DJI Phantom 4 3-in-1 board module (Part 52). is this what you was talking about because this is what I need. I couldn't find it but when you told me to order one from cloud city I went there and it was the first pic that popped up under phantom 4

And And the pin that is supposed to be on the board that broke out is lost. I don't know where it went. It's not stuck inside landing gear wire

The landing gear isn't the problem. It's the board that the landing gear connects to

I just called DJI and they said that part isn't available for sale. And that I have to send it in to have them repair it. I feel like it's worth trying to solder it before I send it in and most likely spend hundreds beings it's dji. This sucks LOL. Waiting for my new shell to get here so I can...

if you zoom in to my pic and see the connector it is circle with a probe in the center. The part on wire looks just like it but the female end. SO the center where the probe goes and the ring have a insulator between. I was thinking that if I put it back on the center pieces will still attach...

if you zoom in to my pic and see the connector it is circle with a probe in the center. The part on wire looks just like it but the female end. SO the center where the probe goes and the ring have a insulator between. I was thinking that if I put it back on the center pieces will still attach...