Thank you.
Also saw your reply in conversation.
Yes, looks like i missed few good posts from my search.
But also those write-ups at github were very explicit in how to use the FTDI board, i.e. requiring 3.3V serial TTL interface.
Thanks much.
Hello,
I believe i am following the conversations and technical steps outlined in this thread, with one minor confusion, which is around 3.3V versus 5V output from the FTDI board.
Most FTDI boards have jumper/switch to have 5V or 3.3V for RX/TX TTL, and separate VCC output for that chosen...
What i was using to verify above claim was from the ipad screen, but obviously with my 08/15 symptom, i won't see any actual pictures/videos saved on sd card, relayed on the ipad screen. I need to actually see from sdcard.
I wasn't sure what following was referring to,
, but after pouring...
Do i toss away P3P?
And I'm left then with Spark and Mavic Air.
P3P out of the box. Set it up. Update FW. And it's fried (at gimbal from overheating during FW update).
Just looking for some advice from the community about what's possible, since i do see some $$$ for replacement part.
Hello,
(apology for a bit lengthy first post)
I believe i've exhausted/performed every "documented" tries (including re-re-re-install of FW from doing reset at link button) from this forum and elsewhere and i've run out of ideas to try, short of repair as next step.
Who would have thought a...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.