After replacing all the hardware I found that replacing the IMU with a known good unit fixed the issues so I purchased a used IMU from ebay. Fingers crossed.
Okay, I have in my possession for the time being a brand new Phantom 4 Pro v2 ( lets refer to it as the "good" drone) to help track down the problem with the problem PP4 v2 ( we can refer to this one as "bad" drone)
I swapped the whole camera/gimbal assembly and it seams to work fine on the...
So I've replaced all 7 flat cables with DJI oem parts. Still suffering the same issue.
So now I've replaced the following:
7 Flat ribbon cables
Flushed all parts thoroughly with deoxit 5D
Replaced Flex cable on gimbal
Replaced Yaw gimbal motor using original housing
Brand new DJI oem battery...
Thanks ianzone. I will check all ribbon cables again but I didn't see anything that worried me much. I found a pack of flat ribbon cables for $30 on Amazon so I may go ahead and try that since it's cheap. I wish there was some sort of schematic for the gimbal so I could attempt to probe it...
Hello all. I have a phantom 4 pro v2 and it has previously crashed into a lake after striking a limb on a tree.
PROBLEM:
Camera gimbal slowly rolls up and then down to both endpoints but then goes absolutely berserk in all directions. I'm getting errors on all 4 "motor esc" as well as...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.