Recent content by Chad80

So if I replace the Main Board will that correct any of this?

Here are my logs The March 2020 dates are mine, any before that were the previous owner.

I am new to drones, so I apologize not knowing all the terminology.

So if it is the DaVinci, does the gimbal board have to be replaced?

I was hoping that I needed the 1.11.30 firmware which is for the ESC Error but that is typically from the 1.11.20 firmware issue apparently. I have made some progress though, the gimbal and camera seem to be working fine, it responds to the RC and I tried taking a picture even though I still...

BTW I did look at the diagram, thank you very much.

I attached the new motor and it has the same issue and I even tried a motor that I know was good and no luck. So after talking with the tech again he is assuming it's a bad board. He said he has a good condition used one he can sell me for $20. Would you agree that it sounds like the main...

So I just left the store, Ian exchanged the motors and I doubled checked. The gimbal seems to work properly however; I still cannot see an image and when the tech connected it to his iPad (I was using a Pixel 3XL) it said No Image Transmission Signal. He said it was either a firmware issue and I...

So I have an update... I went to a local drone store and after the tech looked at it quickly he said it was the motor for sure, so I bought the replacement and he said don't bother soldering that port on the board and comes back and hands me a used but good one and goes " don't tell, it's on...

I would like to try and repair it if I can. I'm going to solder the port back on, from what I can see it looks like that has no damage the solder was just loosened from the crash. If one of the motors doesn't work would the P3 still take off or could that be causing the error noise and light?

You don't think it's worth looking into?

I just purchased a Phantom 3 Pro off CL that was in a crash. He told me the drone was in good shape aside from the gimbal arm being broken but he couldn't get it to fly. So I paid $80 for it and got the drone, 3 batteries, 8 props, controller, broken gimbal arm and pro camera. I have installed...