SO I had my phantom running sweet with the T8J and had an Arris gimbal running on it. I upgraded to the Zenmuse and after installing it ( had to upgrade the Phantom firmware along with the install ) I can no longer start my motors and get this error in the Naza MV2 software (2.16):
Motors Start...
I wish it was the case for me. I have tried reinitializing and no joy. My problems started after a simple landing and then the motors just would not start up so I wonder if something major went screwy
So. I landed my Phantom swapped batts and then the motors refused to start. Went into Naza all seemed fine but needed firmware upgrade so did that, reimported DJI default config, re-calibrated IMU, made sure Futaba T8J was communicating and re-powered. Green/ yellow then fast flashing solid reds...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.