Thanks all. This was very helpful indeed.
I connected to the PA Software, entered NAZA mode, and tested the S1 and S2 switches. S2 works fine, S1 - no response.
I must have been putting to much strain on the switch while calibrating and probably calibrating too often.
Looks like I'll need...
Thanks all, very helpful. I was thinking the switch is bad, but not sure.
Can one of you tell me how to test the switch in the PA software? I haven't yet gotten enough experience yet to determine if the switch is non-functional.
Thanks again for the help and advice!
Unfortunately, I updated the app and the firmware. Wish I could go back, but that is another story.
I always calibrated the compass before each flight because I travel a lot.
But now, I cannot enter compass calibration mode at all using the top right switch. I've tried changing the flip...
I know everyone has different opinions and experiences regardless of the topic, but I did want to post a testimony of my own recent experience with DroneFly customer support.
I had a defective Vision camera and reported it to DroneFly. After sending some example footage they promptly responded...
I did a pretty extensive search on the forum to see if this was posted already. I bet it has, but couldn't find it in my queries. If it has been posted already, my apologies. New to the P2 and and this forum. Hope to make some good friends and contacts.
http://youtu.be/ooPzr1vzmGY
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.