1- Phantom 4 Pro drone in good condition
1- Controller
2- smart batteries/good condition
1- triple bank battery charger
1- single battery charger
1- camera & gimble / good condition
7- props
1- carry case / original
1- sun screen
$625.00
Is it just me or has anyone seen a problem with installing a new GPS module and the plug end on the module wasn't matching up with the end on the ten pin power board. I haven't been able to plug the two together after installing new ones of each product.
My mistake it's not the high capacity battery but one of my other battery's. I am speaking of the battery case itself. I have two other battery that seem ok. The battery has ten connection terminals and from that the voltage is distributed to different function in the drone. If movement from the...
It seems that my high capacity battery 5870 ma. battery isn't fitting snugly in the Phantom 4 case . With this happening it seems to cause a intermitting problem; which in turn causes a loss of the GPS signal as well as going into OTI mode and loosing compass direction.. While in flight this may...
I had Drone Nerds make repairs on my drone because it was loosing GPS signal , compass reading and going into Atti mode. Drone Nerds replaced the 3 in 1 circuit board . My first attempt of flying the drone after repairs; the done would't take off because in was showing a Otti fault. Contacted...
Yes you are correct. After doing more homework I became more aware of flying in Atti. mode. The thing with what happened to me is I was out of vision site when it switched to Attitude on it's own. Luckily I could hear the drone and managed to get it back by sound and then vision. Any ides what...
I noticed if I switch from p mode while in flight to A mode the drone starts flying backwards and I have no control of the drone until I switch back to P mode. I then did a take off in A mode and the drone again starts it's own flight without control from me.
Any suggestions on what is taking...
When I connect to the DJI GO 4 and go to calibration for the front sensors the screen for the dots to do the alignment fail to show up.
Any suggestions?
I noticed on a Utube video that a set of propeller guards for Phantom 4 and 4 Pro would be held in place with the help of a fold down latch. Looking on DJI website they say that item is not available in my area. Anyone know where these guards are coming from?
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.