Recent content by Beefsteak

I haven't needed to tighten any blades so far, just remove them, and realising how difficult it has been to loosen them without the tool I doubt you would need to tighten them any more than finger tight in the first place!

Let us know how you go on, because if they cause hassle as you say let pay pal sort it out, failing that I can sort you out with the details of a good 'fixer' this side of 'the pond' (Funnily enough he's not that far from Huddersfield)

Mine was fixed for free, although they wanted me to pay the postage at first, I questioned their logic, "Why should I pay to post something that you have supplied faulty" They huffed and puffed but in the end relented and payed it (It took a fortnight, but instead of paying the £35 it had cost...

Amazing piece of kit that, complete blade change in 1 minute as opposed to half an hour............. LOL

Aha.................................. Pilot error! Thanks Ian

Is there such a thing as a tool to hold the motor still whilst changing blades? I only ask as I'm a bit loathed to holding the motor still (Or rather attempting to hold the motor still) with a screw driver whilst I remove them blades.

I had a compass error on my 3 Pro (And a very loud fan) from the moment of purchase. I contacted the people I purchased from who are USA based, I'm in the UK, they got me to post it to a UK address for repair, he changed the fan and compass unit telling me that he'd had to do quite a few and...

Thanks Rod, I thought I was on the 3 pro board! No wonder I didn't get any replies Ian

How do you know which firmware upgrade you made? I followed the instructions when I got my new phantom 3 pro, on the memory card it says "P3X_FW_V01.09.0060.bin" Is that the right one please?