No tools are needed to do this work its a simple push fit on all the connections so just gently push and make sure all the plugs are into the slots same on the ribbon cable a gentle push to make sure its gone into the slot .
I would check all the wire connections to the the drone from the gimbal
There are two plugs that are easy to remove these plug into the bottom of the drone.
If they are ok and connected good the nexttni g I would check is the ribbon cable this us very easy to come loose make sure its pushed all...
I will try it out later today and see what happens
It may just be the area I'm in most of the time it's fine but strangely it happened twice around the same time in the eve so it mat be that someone is doing or using something that's making it screw up
Hi
Ok so what is the issue does it need a compass caibration
Actually it did show an error when i switched it on so i reset both the AC,the app and the RC and it was good and it flew about 8 mins came back landed under a rth went up again before the issue
The error was a compas error where it...
Thanks for the info I think you are correct
When I lost my first drone it had shown some interference issue and again it did it tonight but this time I managed to recover it.
It's something I need to watch out for.
Thanks again
After losing a drone 3weeks back using litchi I bought another p3s ad using it tonight and almost the same thing happened
It had 11 sats locked in but switched itself into atti mode from pgps
I managed to control it and it did switch back into gps mode but my question is why do I have a faulty...
I'm way out of any source of interference but 1 km is the best I can do however the terrain is hilly and very boggy .
Also does your range differ depending which app you use and what is the least amount if sats you would fly with
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.