Went even further and found another flight with this battery on the same day 16 november 2022. The log shows that after the drone takes off the voltage drops to 12V almost instantly. I plotted the height graph too and it shows rapid descent (maybe a crash too).
Then the drone reports the...
Moved forward with the analysis of the logs. I checked 10 logs before the flight and only one flight with the same battery was on 16 november 2022. I think it was just a motor test as the flight data is very short (50s), no GPS, Ultrasonic sensor height 0, and the capacity percent remained 63%...
Thanks for the comments, yes, I was not the pilot. I also think that taking off with 40% battery calls for catastrophy. However it would be strange that the drone lost power mid-air but dropped with its battery still in place and turned on. Maybe some power fluctuation that restarted the FC? In...
Thenk you @Meta4 for your assistance! I don't have the txt log yet (I suppose I should get it from the RC, I will try tomorrow). In the meantime I uploaded the DAT to Wetransfer and here is the link for it: FLY188.DAT
I found this strange graph in CsvView:
PPMSned and PPMRecv graph is moving...
Hello Everyone,
I am trying to find out the exact cause of a sudden fall mid-flight. This was not my drone. I repair drones since 2016 (1000+ repaired drone) and I have some experience in analyzing log files with csvview and airdata but I think I can learn more. I cannot find any clue in the...
So after many tries I think I am stuck.
I replaced the OFDM module 2 times with known good modules - no solution.
I replaced the OFDM - GIMBAL ribbon cable with another one - no solution.
I even replaced the camera module and the gimbal flex module - no solution.
GetFPGAstatus err...
I reflashed the NAND with the primary kernel image, you can see my log here. However still the same error occurs when I start the drone.
https://pastebin.pl/view/c22fb2ea
Any other ideas? I still cannot access USB to reflash everything from there.
Hi Everyone!
I need a good piece of advice, let me explain.
I am new to this forum but I am not new to this scene. (I am repairing drones since 2016, I repaired more than 1000 drones successfully.) I also repaired several P3P gimbal boards with fw extraction and reflashing before these tools...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.