Hello, I have been learning how to use Litchi in planning some waypoint missions... also using DJI Go app as well...
I have experienced the same action in executing the RTH command in both apps where the drone starts to drop in elevation from where its position is when the RTH signal is received.
After performing a compass calibration in DJI Go, the RTH command worked well for a while, but at some point, this same action returned.
Question. does performing a compass calibration one of the solutions for this RTH issue?
Question. I am using the DJI Smart Controller... when getting the voice commands from Litchi, it is not an understandable, so I am presuming is that this compass calibration is the same as in DJI Go, where you do the horizontal counterclockwise rotation, followed by a vertical counterclockwise rotation.
Thanks
Rob
I have experienced the same action in executing the RTH command in both apps where the drone starts to drop in elevation from where its position is when the RTH signal is received.
After performing a compass calibration in DJI Go, the RTH command worked well for a while, but at some point, this same action returned.
Question. does performing a compass calibration one of the solutions for this RTH issue?
Question. I am using the DJI Smart Controller... when getting the voice commands from Litchi, it is not an understandable, so I am presuming is that this compass calibration is the same as in DJI Go, where you do the horizontal counterclockwise rotation, followed by a vertical counterclockwise rotation.
Thanks
Rob