Ok so as most know my P3S crashed a while back. Since then I have bought another one as well as one that’s functional just needs to be put back together.
Anyway, here is where I’m stumped. I put a gimbal off of one of the used ones I purchased onto my original that crashed. My remote will fly the drone fine but I don’t have telemetry, video, battery status, etc. Now comes the part I find strange. If I turn on the remote from the drone the gimbal came off of it will show the video, settings, battery, etc. that remote however says signal lost so will not power up rotors, fly drone or anything. I have tried to pair both of the RC to the AC. I hold the button on the AC but both remotes time out while pairing.
How would I go about getting one controller to work everything? The one that will fly, etc will also move the gimbal. The one that won’t fly but shows telemetry, etc won’t move the gimbal or do anything else except make the video come on. Would it be an app problem? Firmware? Pairing? I’m at a loss and also not sure why neither remote will pair to the P3.
I also read somewhere that you could roll back the firmware in the DJI go app but I can’t find it anywhere on there. Thanks for any help in this.
Anyway, here is where I’m stumped. I put a gimbal off of one of the used ones I purchased onto my original that crashed. My remote will fly the drone fine but I don’t have telemetry, video, battery status, etc. Now comes the part I find strange. If I turn on the remote from the drone the gimbal came off of it will show the video, settings, battery, etc. that remote however says signal lost so will not power up rotors, fly drone or anything. I have tried to pair both of the RC to the AC. I hold the button on the AC but both remotes time out while pairing.
How would I go about getting one controller to work everything? The one that will fly, etc will also move the gimbal. The one that won’t fly but shows telemetry, etc won’t move the gimbal or do anything else except make the video come on. Would it be an app problem? Firmware? Pairing? I’m at a loss and also not sure why neither remote will pair to the P3.
I also read somewhere that you could roll back the firmware in the DJI go app but I can’t find it anywhere on there. Thanks for any help in this.