I've got my iosd mini installed inside my phantom. I've downloaded the iosd assistant and plug in the USB to the iosd. I go to info tab and select firmware update and it says no device is connected. The phantom is powered up and the iosd mink is blinking green. My fpv screen shows a clear feed and the iosd mini info is on the screen, but it does not show how many satellites are connected or how far high the phantom is. But I'm just connecting in my house, haven't flown it yet with it hooked up.
I've tried 2 different pc's. And when I plug in the iosd to the PC, I hear a sound like something is being connected, so I don't think it's the cable (I've used same cable for phantom assistant and it works fine).
I've read that the PC driver needs to be installed along with the assistant, but I see no driver on the dji support page. What am I doing wrong?
Btw- I don't have the phantom assistant or rc assistant installed on either of these pc's. I have those installed on my Mac and am only installing the iosd assistant on a PC because it's not available for Mac. Don't think that should matter, but mentioning just in case.
Thanks.
I've tried 2 different pc's. And when I plug in the iosd to the PC, I hear a sound like something is being connected, so I don't think it's the cable (I've used same cable for phantom assistant and it works fine).
I've read that the PC driver needs to be installed along with the assistant, but I see no driver on the dji support page. What am I doing wrong?
Btw- I don't have the phantom assistant or rc assistant installed on either of these pc's. I have those installed on my Mac and am only installing the iosd assistant on a PC because it's not available for Mac. Don't think that should matter, but mentioning just in case.
Thanks.