- Joined
- Aug 14, 2016
- Messages
- 1,075
- Reaction score
- 169
- Age
- 38
I just updated the aircraft firmware through assistant 2 since when I try to update it through dji go 4 it gives me this screen. I unplug from controller and plug into aircraft using the provided dingle and it exits the screen and goes back to the main page where it says GO FLYDid you install an RC firmware update yet? If not, try formatting your memory card and then restart everything.
No I haven't installed an rc firmware yet.How about my other question?
If you do start to update things, just make sure to update the drone first, before updating the RC. This prevents a lot of hassle and frustration.I'm not getting the download option. But my RC firmware has a - behind it? Any ideas why?
The problem is I can't figure out how to install the RC update. It's not giving me the option like the p4 and mavic did through dji go main screenIf you do start to update things, just make sure to update the drone first, before updating the RC.
Ok I'll try that and report back. Should I factory reset the drone?Did you install an RC firmware update yet? If not, try formatting your memory card and then restart everything.
The RC gets updated from the main screen on dji go 4. Correct?One step at a time my friend
As Kman stated, you may not get an "RC update" notice until you finish the drone update first.The problem is I can't figure out how to install the RC update. It's not giving me the option like the p4 and mavic did through dji go main screen
We use essential cookies to make this site work, and optional cookies to enhance your experience.