Ok, I finally bit the bullet and updated.
Firmware:1.1.411
App:2.8.3
Range I achieved without an ounce of signal loss was 3km as that is what I set it too.
When pressing video record button there is a 1.5sec delay before it starts recording.
Recorded in Dlog and switched back to normal Rec709 and it would not change. I had to reset camera settings in order to get back to normal colourful rec709.
Gimbal is level, no signal loss, nothing else noticed. All seems quite normal and done performing as previous.
Noticed the squeaky gimbal boot up noise s gone. It didn't bother me anyways.
Sent from my iPad using PhantomPilots mobile app
Firmware:1.1.411
App:2.8.3
Range I achieved without an ounce of signal loss was 3km as that is what I set it too.
When pressing video record button there is a 1.5sec delay before it starts recording.
Recorded in Dlog and switched back to normal Rec709 and it would not change. I had to reset camera settings in order to get back to normal colourful rec709.
Gimbal is level, no signal loss, nothing else noticed. All seems quite normal and done performing as previous.
Noticed the squeaky gimbal boot up noise s gone. It didn't bother me anyways.
Sent from my iPad using PhantomPilots mobile app
