Phantom 2 2.4g receiver in to a phantom 1 2.4

[greenbriggs9]

Hi all, newbie here.
I have bricked my p1 receiver after doing a firmware update.
I can no longer use my remote with my p1 at all.
I have done the factory reset and made sure it is set to D bus.
I have done everything possible.
The led light on the WM300 2.4g tx rf v1 does not light up at all. So I can't pair up the devices.
I have enclosed a photo of my now defunct receiver (does anyone have a spare for sale)?
My question is,
I have noticed that there are identical looking receivers for the p2. Identical in every way.
Would one of these work on my p1 ?
Thanks.

 

[discv]

Yes, provided that your P1 is a v1.1.1- dual antenna. DJI part 31.
DJI Part31 Phantom 2.4Ghz Receiver V3 - BUY [email protected]

Prices vary wildly- I know the above is nil stock- but it's a guide.

 

[greenbriggs9]

Tha

Yes, provided that your P1 is a v1.1.1- dual antenna. DJI part 31.
DJI Part31 Phantom 2.4Ghz Receiver V3 - BUY [email protected]

Prices vary wildly- I know the above is nil stock- but it's a guide.

Thanks very much.
I have my eye on one on eBay.
It's a dual antenna, just the same.
It's a v4 were as mine is a v1. But for £30 it's worth a punt

 

[greenbriggs9]

Genuine DJI Phantom 2 Spare Part No.5 2.4GHz Receiver RX RF V4

 

[greenbriggs9]

That's the one I have my eye on.
You reckon it's good to buy?

 

[greenbriggs9]

Sod it....
I have ordered dji part 31 from the US.
Might aswell get a part that's going to work.