I've searched this forum for an answer before posting this. I hope I didn't miss something. My apologies if I did.
I recently connected my PV2 to the Assistant Software version 3.0 to verify Controller and IMU calibration. The assistant immediately downloaded and installed version 1.0.1.30 firmware for the P330CB, which I believe DJI calls the "Phantom 2 Vision Central Board". It was version 1.0.1.27.
I checked the DJI download page where they list the current versions of all the firmware / software for both the Vision 2 and the Vision 2+, and they are listing the Central Board firmware at version 1.0.1.27 for both. Looking further into this, it appears the version downloaded to my Phantom is to address gimbal 'jitters' for the Vision+. (There's a number of threads in the Vision+ forums).
3 questions:
Is the P330CB the Phantom 2 Vision Central Board?
Has anyone else had this update pushed via the assistant to their PV2?
Why is DJI updating PV2 firmware with PV2+ firmware.
Thanks,
Jim
I recently connected my PV2 to the Assistant Software version 3.0 to verify Controller and IMU calibration. The assistant immediately downloaded and installed version 1.0.1.30 firmware for the P330CB, which I believe DJI calls the "Phantom 2 Vision Central Board". It was version 1.0.1.27.
I checked the DJI download page where they list the current versions of all the firmware / software for both the Vision 2 and the Vision 2+, and they are listing the Central Board firmware at version 1.0.1.27 for both. Looking further into this, it appears the version downloaded to my Phantom is to address gimbal 'jitters' for the Vision+. (There's a number of threads in the Vision+ forums).
3 questions:
Is the P330CB the Phantom 2 Vision Central Board?
Has anyone else had this update pushed via the assistant to their PV2?
Why is DJI updating PV2 firmware with PV2+ firmware.
Thanks,
Jim