New 3-Axis Gimbal

[Nsrwholesale]

Just found this:

https://www.youtube.com/watch?v=bO4bhITvIwk
and
https://www.youtube.com/watch?v=SKmVlSSyr78

looks legit

 

[Cyclone]

That looks nice and tidy. I wonder if its the same person that was designing one a few months ago and said he would have video by the end of April. He was doing a 3 axis gimbal.

 

[RCRookie]

Wow.. I like the looks, very neat, no wires, who is the maker?

 

[DKDarkness]

Wow.. I like the looks, very neat, no wires, who is the maker?

Uploaded by Daniel Fink (German)

Looks like he is using iPower GBM3506H-130T, 64g gimbal motors with hollow shaft (14mm heigh). It seems he has cut part of the "ears" of his FC200 to make it fit, but still uses tall landing gear to make it fit. That is a total of 192g for the motors alone, not counting in the weight of the FC200, the actual gimbal and the controller... Probably why there is no footage of it flying... yet

There would be some idea in combining the +5 and GND wires, as only the signal wire needs to be seperate (same +5 and GND for all 3 servos and IMU) Might introduce noise on the IMU though.

 

[Luap]

Here is discussion on German form
http://www.kopterforum.de/topic/10858-e ... era/page-5

 

[DKDarkness]

Looks like he has been working on it for a while now: https://www.youtube.com/user/tamazight2011ify

 

[sangfhas]

What' about this one

https://www.youtube.com/watch?v=zCydKXGEr8w

 

[brushlesheaven]

Very cool unit and looks much lighter than some other ones out there...

What' about this one

https://www.youtube.com/watch?v=zCydKXGEr8w