Just before Christmas last I purchased one of the all aluminium Goodluckbuy gimbals which I believe was running on some nulled version of the Alexmos firmware. Recently the control board died, failed voltage regulator, so I purchased a replacement board and installed the opensource BruGi V50 200 firmware. The board is identical in everyway to the original one supplied by GLB. I have managed to tune it up so that when power is applied the gimbal is steady under extreme movement but I cannot seem to get the tilt function to work as it did with the original board running the nulled firmware.
I have attempted to load a nulled version of the Alexmos firmware but this has failed.
I am hoping that there is another Phantom user who has successfully installed the opensource BruGi software and enabled the tilt function on their Phantom and can help me to get this feature working again.
Regards
Nidge
I have attempted to load a nulled version of the Alexmos firmware but this has failed.
I am hoping that there is another Phantom user who has successfully installed the opensource BruGi software and enabled the tilt function on their Phantom and can help me to get this feature working again.
Regards
Nidge
