Firmware failure DDDDDD BUZZING SOUND

[Mark Donnelly]

Hey guys,
Gave my P3P a tiny knock from knee height into a wall at 1mph. Still flies in atti mode but no readings for height, distance, Etc. Was advised to reinstall the firmware by a professional as the knock may have affected it and should cure it.

So I formatted the sd card, extracted the bin file and set it to update.
Sounds like a normal update D-D-D then a long buzzing sound for infinite time and solid red light above gimbal.

Result file says update failed, try again.

Hidden log file says cannot detect source. Screenshots below

Please help

Sent from my iPad using PhantomPilots

 

[chazz]

I cant tell you what is going on but I can tell you the devise that it can't detect...

'target': 'm1700', Stores firmware for visual positioning module 'camera'
'target': 'm1701', Stores firmware for visual positioning module 'sonar'

The VPM is on the bottom of the phantom behind the gimble right under the battery...You can take it off and look to see if the cables are attached its very easy to do...