Error 29 - constant fast flashing red LED

[thomas55218]

Hello phantom pilots,

my Phantom has an issue...

I have a constant fast flashing red LED after powering on my phantom. If I connect the phantom to the computer using the software, I am getting an error "ERROR29". Sounds like the settings for my transmitter are wrong. If I have a look to the throttle in the software, it is not in the middle. It is on the left of the bar.

After connecting the phantom to the computer, I can control the bars using the transmitter for a few seconds. After that, it looks like the software get no more information from the copter even it is connected and the status of the software says that it is connected.

Any idea?

 

[ZonComGMZ]

Try recalibrating the sticks, update the firmware on the Phantom and on the Transmitter if needed. See if you get the same problem with the Transmitter Assistant stick readings as you do in the Phantom Assistant stick readings. You'll need to plug the Transmitter in the USB port on the PC. USB may be external or internal on Transmitter.