Members-
I will share something that happened yesterday. I connected my Phantom to my
laptop as I have done many times before. Upgraded the firmware and checked everything
out. I was doing the calibration as I always do after an upgrade and watching the display
bar proceed across- it suddenly stops. No movement for a long time. Went back and
checked battery status- battery not recognized. Noticed blue indicator not lit and checked
cables. Unhooked and shut down- the rehooked up and started the process over again.
No communication with Phantom.
Unhooked and uninstalled the software and rebooted the computer then reinstalled
the software. Hooked up and everything is normal. Is this causing some of the problems
I read about bad batteries and compass glitches? The quad is flying fine and all controls
are working well as I really tested it really hard.
Just wondering-
Al
I will share something that happened yesterday. I connected my Phantom to my
laptop as I have done many times before. Upgraded the firmware and checked everything
out. I was doing the calibration as I always do after an upgrade and watching the display
bar proceed across- it suddenly stops. No movement for a long time. Went back and
checked battery status- battery not recognized. Noticed blue indicator not lit and checked
cables. Unhooked and shut down- the rehooked up and started the process over again.
No communication with Phantom.
Unhooked and uninstalled the software and rebooted the computer then reinstalled
the software. Hooked up and everything is normal. Is this causing some of the problems
I read about bad batteries and compass glitches? The quad is flying fine and all controls
are working well as I really tested it really hard.
Just wondering-
Al
