Crashed phantom, esc error

[Seancrw]

Ran drone into a tree like an idiot Came down and hit the ground upside down, continued to spin until I was able to turn it off. The gimbal/camera came off, but amazingly seem fine, connectors are all good, lens somehow managed to not get broken or scratched. Top cover has a small dent, few cracks, all cosmetic.

Trying to use the drone again I get 'ESC Status Error. Turn off aircraft and restart'. Motors won't spin at all.


I took it apart, motors all spin fine by hand, motherboard seems fine -

except this capacitor coming unglued...

Could that be the cause ? And would I need a new capacitor or would this one still be fine, I know nothing of electronics so bare with me haha. I also read a bad motor or motor esc could cause this. Any input would be appreciated greatly.

 

[hunch]

you can use that one and solder it back on but you will require a good thin solder, some flux and steady hands.
but that is most likely your culprit right there yes