So I was flying my drone and unfortunately at the speed I was flying the avoidance system did not avoid a street lamp, so after striking it my drone spun downward and landed in the grass for a softer landing from 25' then the actual hit of light pole. So after the crash I powered it up and the camera constantly rolls up and down, I replaced the broken landing gear with the new GPS and re calibrated with DJI assistant and did a gamble calibration but no change in camera. I have no control over it and it still continues to roll up and down after boot up. I can see picture thru phone but that's it.
Crashed my P4P and need camera help
- Thread starter Dee34
- Start date
Sorry to hear of your crash.
It sounds like the gimbal is toast.
Have you done IMU calibration? Worth a try.
It sounds like the gimbal is toast.
Have you done IMU calibration? Worth a try.
Yes I tried that too with no luck,Sorry to hear of your crash.
It sounds like the gimbal is toast.
Have you done IMU calibration? Worth a try.
I just wonder if there is something that came undone inside that I did not see when I changed the landing gear.
Similar threads
