Last year I crashed my Phantom 3 Standard. It bent the yaw arm but other than that, everything was ok. I finally decided to replace it today. I must have moved the position of the sensors because the camera freaks out every time I turn it on.
I know the standard advice is to perform the IMU calibration. Will this work even if I've changed position of the sensors that the yaw arm slides into? I also noticed I don't have any camera feed on the app. Is this normal since the camera can't figure out what's going on?
Any advice is helpful. Thanks!
I know the standard advice is to perform the IMU calibration. Will this work even if I've changed position of the sensors that the yaw arm slides into? I also noticed I don't have any camera feed on the app. Is this normal since the camera can't figure out what's going on?
Any advice is helpful. Thanks!
