Trying to decide if this “issue” is machine error, or designed properly ?
Only found 1 internet comment that stated “motor not level” but I’m Leary about “leveling” if it’s proper quad design.
Hopefully my stick figure makes sense, the front left and back right “tilt” the motors in ~ 1+mm, the other two are flat level
Thanks for the help
Only found 1 internet comment that stated “motor not level” but I’m Leary about “leveling” if it’s proper quad design.
Hopefully my stick figure makes sense, the front left and back right “tilt” the motors in ~ 1+mm, the other two are flat level
Thanks for the help