4.02 Question

[Buk]

I updated my original V1 Phantom today. Downloaded Assistant software 2.20 and installed 4.02 and imported the appropriate settings. did an advanced calibration, did the compass dance and all seemed fine Although I haven't flown yet.

I thought you could manually test each motor. I find no page or tab in the software to test motors. Am I confused, again, or this test is in some other software/firmware?

Thanks,

 

[EMCSQUAR]

If you open assistant, under Basic, under Aircraft -> lower right side is tab for test motors

 

[Buk]

If you open assistant, under Basic, under Aircraft -> lower right side is tab for test motors

Thanks, right where you said. It provides just a short bump to verify rotation and position.

 

[jumanoc]

Check my video (set louder volume for notice the different sounds)

[youtube]http://www.youtube.com/watch?v=IdkJ7BbEDsE[/youtube]