Recent content by wworrall

I am in Anchorage Alaska and I have this problem big time. It gets a little better after flying for a while but never flies straight despite compass calibrations in a metalic free area. I am not happy with this. It hooks badly enough that I have to constantly put in left or right stick...

advice from newbie: Mine is getting better. Re the MC to warm message, that is a bug. Powercycle the pv2 and try advance cal again, it should finish. only do this on a truly flat surface and no bouncing or vibration of the surface during calib. Also, make sure you are calibrating...

But it was also pointed out in this thread that this issues was corrected with a March 2013 firmware update, so that now the PV2 reconciles true north vs magnetic north based on gps location, adjusting automatically for local magnetic declination. Can anyone confirm this is correct? I am in...

It did work this time. thanks.

Do either of those calibrations include calibrating the IMU? Also , besides a flat vibration free surface, do you have to worry about nearby metal objects during either calibration like you do when doing the compass calibration? thanks btw

Is this a stumper? Just trying to find out what can be done when assistant software always reports that IMU does not need calibration.

No problem! That search tool came up empty, no results, also just for gimbal noise. But the forum search tool did find skyhighdiver's post and replies.

that makes sense, thanks.

What about the inability to do an IMU calibration? Always says "not needed", won't let me do it. Re toilet bowl, the nazam v2 manual on pg 28 says that you have to rotate the gps antenna the opposite direction of the toilet bowl direction (this is under the gray material in the top of the...

good to know, thanks.

Is anyone using the nazam v2 assistant software with the pv2 (I assume it might be different from the version DJI gives us)? There are other settings that can be made with that software I guess, such as height and distance from home limits, etc.

This forum has been very helpful. Solved a few issues already, and taught me a lot. I am trying to figure out a noisy gimbal problem with my new PV2. Since I first turned it on, without motors on, it has fairly loud gimbal noise, like a chattering servo kind of noise but it isn't making the...

You are right. Maybe I had to power cycle the pv2 or restart the assistant software, or maybe I was blind, but now it's all there. thank you.

I switched to naza mode in latest assistant software connected to pv2 with latest firmware. I can find no place in software to pick RTH versus manual for S1 switch for the down position. All I get with IOC enabled is the screen showing the position of S2 and those modes displayed, can't find...

Everyone talks about doing the IMU calibration, but my PV2 with updated firmware and newest assistant software has never let me do an IMU calibration, it always reports "not needed...." when I click on the button. Is this normal? Is the IMU calibration done as part of the advanced calibration...