Guys, good news! I just used a pliers on top with the DJI wrench below and with very little force the prop loosened. The thread underneath was not damaged and hopefully will be aOK.
Blackhawk, Thank you for the advice. Im currently overseas, but thanks for the offer to help. Im afraid your correct that the prop will have to be cut off. Is a dremel tool the only method? Is it possible to put a cut into the prop with a knife then pull it apart? Is the core (black hub)...
The metal hub is not turning, Im holding it with the wrench and it is not moving. The propeller rotates atop the engine post, but it turns with difficulty, and never becomes loose.
Guys, thanks for the feedback.
The propeller does not spin with the wrench holding. So, I believe the engine is good. It rotates and "feels" like the other three engines.
Based on your comments, it sounds like the propeller was "over torqued". But, it dose not budget with the DJI wrench tool...
Phantom Pilots,
I suffered a crash where the Phantom flipped upside down from about 12' and landed on one prop.
The engine runs fine but I cant get the propeller loosened.
Does anyone have any advice to remove a stuck 9443 R propeller? According to the face of the propeller, the "unlock" is...
Dear Phantom Pilots,
Recently, I discovered a small soft plastic piece in my drone box.
I realized my tilt control wasn't working and saw where the piece was missing from, the left side of the camera ball.
I had not crashed the drone and don't remember loosing this screw or attachment, but...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.