Just powered up the P3S with the updated IOS DJi Go App 3.1.6. The pesky Strong interference messages problem seems to be fixed (this time anyway). The controller came up in Wifi channel 10 which was the most problematic before. Not a flight but a living room check where I had seen these...
This weekend my son in law will be here with an Android device so I can compare interference on it and my iPhone. Hoping for a DJI update to fix it but not holding my breath.
Thanks for the info Nigel. Makes sense now. Now when we get the "Strong Interference" message which signal has the interference? I am not convinced it is real but which signal is it?
Wifi - apparently there is both a 2.8 and 5.6 MHz channel. I assume the 2.8 is between the P3S, RC, and my iPhone. The 5.6 is between the P3S and RC. The 5.6 data (camera?) is passed to the iPhone over the 2.8 channel from the RC. Is this anywhere near correct?
Sounds like the compass function in your monitoring device is not working or out of calibration. My iPhone is almost right on. I do have to tilt it slightly to make it perfect.
Sent from my iPhone using PhantomPilots
Yeah but the car battery is only 12v. I would not think this would have step up supply for that price. Maybe though?
Sent from my iPhone using PhantomPilots
There is a YouTube review out there with a neat idea on how to make covers for the exposed terminals. Small piece of card board and scotch tape.
Sent from my iPhone using PhantomPilots
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.