Recent content by VisionXmedia

It could be your wifi module (inside phantom).......having the same problem

Thanks for the reply hunch Its a v2 i think (no holes) i did open it up and gave it a good amount of paste , would of thought if it was the module i wouldn't get anything at all , i did get about 30 seconds by fluke , but cant remember what i did!!!!!!! think it must of been the frustrated...

I am having a similar problem , i can see WiFi status and take photo and video ,also see the sd card and playback within app. I cant get live video or osd info from phantom, i replaced all cables to WiFi module still no joy !!!!! I have posted in all other threads regarding this issue and i am...

Okay, iI have a problem with a P2v+ i purchased used and cant seem to get full control over the Phantom with vision app. I can however start recording , take photos , But everything else , telemetry , Live video feed, Gimble Control ,Sd ,etc are gone. Can this problem be just cable related (...

i also have the same problem, pulled the plug off the 4pin cable think its the tilt control and sd....fair to say no telemetry, video feed or camera control. ordered the cable pack and will install, any tips would be highly appreciated .

Thank god i found this thread, i purchased a second hand pv2+ that had a bad esc.....(it was very cheap) and it has the 4 pin sd and gimble pitch grey cable damaged. all 4 pins are good but the plug is damaged, i put the pins back in the plug , but not getting any display in the app, no gimble...