Recent content by vieks

Tell me about it. Mine broke while putting on the gimble clamp. Pretty sure mine was used or defective since it came with a bent gimble arm and gimble was never recognized in the software. Also stickers were on phantom and serial numbers don't match on box and phantom. When I called dji they...

.....that connects to the camera? I know a lot of cameras have fallen off and the ribbon has ripped, wondering of anyone has fixed? Re connected the ribbon back together?

Andy, separate issue to my question. My issue is that when I plug my phantom in to the software under advanced the gimle tab disappears. When I spoke to dji they said it was a defect. Anyone else have this issue?

The arm is not straight up and down, tilted a bit. Would the camera compensate and level out even if the arm is not perfectly straight? Or does the arm need to be straight, it appears footage is not level.

What about the phantom serial numbers, can you check to see if they match?(what's on the box and what's on the phantom)

My serial number on the phantom is different then the one on the box. Anyone else have this issue? Also my red stickers were already on when I opened the box, wondering if mine was used and not new.

Anyone else have this issue where the large gimble arm that connects the camera is crooked, not going straight down, this of course means pics and videos are not level. Any easy fix for this, I don't want to bend it and have it break. Funny thing is this is a replacement gimble that came off a...

I have the latest software assistant, think version 3.0. When my phantom is not plugged in and I click on advanced I see the gimble option to adjust settings and select fpv. When I plug my phantom in the gimble option disappears. I have upgraded the gimble firmware and everything else but still...

On the sticker on the bottom of the phantom what is the model number of your vision plus? Is it pv331? Also does your serial number start with PH? My serial number does not match the one on my box. I saw this thread for phantom visions but not for vision plus's.

Anyone figure this out? I've had 2 vision plus's both had stickers on them and just noticed the one I still have does not have matching phantom serial numbers. Repeater is same but one on the bird and box do not match just like everyone else has said. I bought in NYC (stc) if anyone else bought...

Went through that today also. Pretty sure their entire support staff is fielding PV2plus problems all day every day. This scremns to 2 things. 1) They are under staffed and 2) this product was released too early. Practically every post on here has some type of issue. I am personally on my 2nd...

100 percent sure I am not in tilt mode. this is really pissing me off. just tried to call dji for support but they are jammed with calls and I cant even be put on hold, just get disconnected. When i plug into computer and run the software the camera jumps around and wiggles and then slowly...

Ribbon looks connected , is there a gimble reset or something that checks the tilt motor? Just flew again and after 1 minute camera dropped down again and I could not tilt back and said remove gamble clamp again.

You need to delete last post here and start a new post with your question. My post is something completely different.

OK I'm on my 2nd PV2 plus and have flown it about 5 times with no errors or crashes and kept in pristine condition. Now all of a sudden in the middle of my flight the tilt on the camera is non responsive and just dangles. This has happened on my last 3 flights. When I set it up to fly and check...