Recent content by vanhoand

  1. V

    FPV loses signal 1-2sec after initialization - Boscam TS352

    I ran into a new problem with my phantom2 FPV setup yesterday. Hopefully someone can diagnose is with the video I took of the symptoms. Its the Here's the back-story: Took the setup to the local hobby shop to pick up some new clover leaf antennas for the FPV system. They only had 2 Rx antennas...
  2. V

    LED Flashing code during flight

    hah.... never would have guessed that one. I checked out the no fly map on the DJI site and sure enough, our house is just on the edge of the outer yellow circle around Detroit Metro. Thanks for the tip!
  3. V

    LED Flashing code during flight

    Can anyone help ID this LED flashing code? https://www.youtube.com/watch?v=l03nVwpdWuA&feature=youtu.be https://www.youtube.com/watch?v=l03nVwpdWuA&feature=youtu.be Started getting this red flashing about 5 minutes into a flight. Happened 2 times now. I didn't notice any impact on flight...
  4. V

    X1 Calibration Issue

    Solution!!! I finally found a post somewhere (can't remember i've looked at so many pages the past few days) that addressed the calibrating from the RC assistant even though it says it won't work.... LIES!!! it does work. From the RC assistant, click the calibrate button and you'll be...
  5. V

    X1 Calibration Issue

    No, still working through it and looking for help... I'm considering doing the pot replacement and putting a thumb dial on the face of the RC but I'd hate to do all that if its an issue with the board itself and not just the x1 pot. We leave for Peru in a week though so I don't have time to...
  6. V

    X1 Calibration Issue

    Looks like there's something wrong with the potentiometer itself... Here's another video I just took showing the direct input into the pot and the feedback shown on the P2 Assistant.... https://www.youtube.com/watch?v=r1yjiWTo5rc As you can see, the monitor is all over the place as I cycle max...
  7. V

    X1 Calibration Issue

    I'll give it a shot and report back...
  8. V

    X1 Calibration Issue

    Thanks for the reply. I went through the calibration process again with the same results as reported in my original post. I recorded a video this time to show what's happening better: https://www.youtube.com/watch?v=M6ZdmObOYq8 As you can see, there is no linearity in the slider, the min and...
  9. V

    X1 Calibration Issue

    Hi guys, Got my new P2 and H3-3D in last week and got all the firmware updated and everything put together. I've notice that when cycling the X1 slider, the gimble doesn't pan to the max and min. I hooked the P2 back up to the assistant to calibrate it but before I hit start, I saw that when...